Omega waterstops for perimetric joints and on top of compression and tension joints.
durajoint EPDM plate 300 is a black Ethylene Propylene Diene Material (EPDM) rubber supplied in 20 mm thickness.
Uses
Waterproofing concrete structures such as tunnels, dams & reservoirs
- Unsuitable for use with oils, greases and hydrocarbon solvents
- Has limited abrasion resistance
Advantages
- Exceptional resistance to ozone and aging
Physical Properties
| Material | EPDM |
| Colour | Black |
|
Hardness (Shore A) ASTM D-2240 |
60±5 |
| Density ±0,02 (kg/m3) | 1.11 |
| Tensile ASTM D-412 (MPa) | > 15 |
| Elongation ASTM D-412 (%) | 490 |
| Compression stress with 25% deformation @ 70 oC x 168h |
<11% Loss |
| Resistance to Ozone @ 70 oC x 168h (ASTM D-1171) |
Yes, Elongation 289% Tensile 10 MPa |
| Size | 300 mm x 20 mm x 10 m |
| Code | 36647 |
Application
Omega waterstops are external seals placed on the perimetric joints and on top of the compression and tension face slab joints. Omega waterstops shall be manufactured with EPDM material, including the plate. Compression and perimetric joints shall be equipped by a 20 mm thick durajoint EPDM plate 300. The EPDM material shall conform to the specifications as per the Typical Properties table and shall be installed as shown on the drawing.
(Donwload technical data sheet to view drawing)
Model Specification
durajoint EPDM plate 300 x 20 mm
High performance EPDM plate for Omega waterstops for perimetric and compression joints.
The plate will be durajoint EPDM plate 300 to equip a 20 mm thick compression and perimetric joint.
Storage
Should be stored protected from extreme weather conditions.
Health & Safety
Product safety information required for safe use is not included. Before handling, read product and safety data sheets and container labels for safe use, physical and health hazard information. The safety data sheet is available from your local a.b.e.® sales representative.
Important Note
This data sheet is issued as a guide to the use of the product(s) concerned. Whilst a.b.e.® endeavours to ensure that any advice, recommendation, specification or information is accurate and correct, the company cannot accept any liability for application – because a.b.e.® has no direct or continuous control over where and how a.b.e.® products are applied.
Further Information
Where other products are to be used in conjunction with this material, the relevant technical data sheets should be consulted to determine total
requirements.
a.b.e.® has a wealth of technical and practical experience built up over the years in the company’s pursuit of excellence in building and construction
technology.