hydroproof® PRO is an economical, water-based ACRYLIC WATERPROOFER – FIBRE REINFORCED
No membrane required for gaps up to 2 mm.
Uses:
- For waterproofing all types of stable flashings
- For waterproofing parapet walls
- Sealing of joints, laps and roofing screws on corrugated roofs and gutters
Advantages
- hydroproof® PRO is an all-in-one system
- There is no need for separate primers on porous surfaces
- hydroproof® PRO has excellent weathering properties, adhesion and is tough, flexible and non-toxic
- hydroproof® PRO comes in a wide range of colours
Surface Preparation
Ensure all surfaces are clean dry, sound and free from all laitance, fungal growth, grease, oil or loose and flaking particles.
Bonding / Priming
Ensure all surfaces are clean, dry, sound abd free from all laitance, fungal growth, oil or loose and flaking particles.
Prime metal surfaces with 4 metal DTM.
Mixing
Stir well before use.
Coverage
3.34 ℓ/m² full system.
Application
1st coat: (after priming): apply by brush/roller using 1 ℓ/m².
2nd coat: once 1st coat has dried (2 – 3 hours), apply 2nd coat by brush/roller using 0,5 ℓ/m² and ensure membrane is fully saturated.
3rd coat: once 2nd coat has dried, apply 3rd coat at different angle to 2nd coat using 0,5 ℓ/m² .
An abe® membrane MUST be applied for gaps greater than 2 mm.
Drying time @ 25 ºC
Touch dry: 1 hour
Hard dry: 24 hours
Full cure: 7 days
Cleaning
Whilst still wet, clean equipment with water. If hydroproof® PRO has dried use abe® super brush cleaner followed by washing with soap & water.
Caution
Always ensure that hydroproof® PRO is applied to well drained roofs. Use abe® membrane for gaps > 2 mm.
Protection on Completion
Whilst hydroproof® PRO is designed for an extended life, it is important to apply a maintenance coat of hydroproof® PRO every 3 to 4 years.
Packaging
Available in 5 liters.
Colours
Red, grey, charcoal, burgundy, white, green, brown and terracotta. Download data sheet for colour reference.
Important Note
This data sheet is issued as a guide to the use of the product(s) concerned. Whilst a.b.e.® endeavours to ensure that any advice, recommendation,
specification or information is accurate and correct, the company cannot accept any liability for application – because a.b.e.® has no direct or
continuous control over where and how a.b.e.® products are applied.
Further Information
Where other products are to be used in conjunction with this material, the relevant technical data sheets should be consulted to determine total requirements.
a.b.e.® has a wealth of technical and practical experience built up over years in the company’s pursuit of excellence in building and construction technology.